6400 Series

Application- Commercial Buildings

2 or 3 HP Sewage or dewatering submersible pumps, 4” flanged discharge

Find Nearest Representative

Product Specifications

Voltage Ability	200 / 230 / 460
Phase	1 & 3
Hz	60
Discharge Size	4″
Solids Handling	3″
HP	2 & 3
RPM	1750
Seals	Upper – Carbon Ceramic Lower – Silicon Carbide/Carbon
O Rings	Viton
Impeller	Cast Iron Vortex

Durable, epoxy coated cast iron construction
Motor: 1 Ph or 3 Ph, oil-filled, hermetically-sealed, automatic reset, thermal overload protected (1 Ph)
Bearings – Upper and lower ball bearings
Stainless steel motor shaft
Dual mechanical shaft seals – upper carbon/ceramic, lower silicon carbide/carbon. Optional seal materials available
Viton O-ring seals and cover gasket
Impeller – non-clogging, cast iron vortex design passes 3″ (76 mm) spherical solids
25′ (8 m), UL listed, 3-wire neoprene cord and plug. Longer cords available in lengths of 35′ – 50′ (11 – 15 m)
No screens to clog
Stainless steel screws, bolts and handle
4″ Horizontal standard ANSI flange
Corrosion-resistant, powder coated epoxy finish
Moisture sensors available for early warning of seal failure (optional)
100% computerized tested

*See ZM1376 for listed models.

Voltage Ability	200 / 230 / 460
Phase	1 & 3
Hz	60
Discharge Size	4″
Solids Handling	3″
HP	2 & 3
RPM	1750
Seals	Upper – Carbon Ceramic Lower – Silicon Carbide/Carbon
O Rings	Viton
Impeller	Cast Iron Vortex

SELECTION GUIDE

Single or double piggyback variable level float switch pump control using the 15 amp plug and receptacle. Refer to ZM1536.
Single piggyback variable level float switch, hard wiring the pump lead wires to the float switch leads.
Refer to ZM3376 and select the correct simplex control panel listed for the pump. Refer to ZM1536 and select the desired variable level control switch, 3 required.
Refer to ZM3376 and select the correct duplex control panel listed for the pump. Refer to ZM1536 and select the desired variable level control switch, 3 or 4 required.