Check out the Zoeller YouTube Channel for tips, training, and product videos!

X
MENU CLOSE
Commercial Duty Pumps

6160 Series

6160 Series

Application- Commercial Buildings

0.5 or 1 HP Effluent or dewatering submersible pumps, 1.5”, 2” or 3” NPT vertical discharge

Find Nearest Representative
  • Durable, epoxy coated cast iron construction
  • Motor – 1 Ph or 3 Ph, oil-filled, hermetically-sealed, automatic reset, thermal overload protected (1 Ph).
  • Bearings – Upper and lower ball bearings
  • Stainless steel motor shaft
  • Dual mechanical shaft seals – Upper carbon/ceramic, Lower silicon carbide/carbon. Optional seal materials available
  • Impeller – non-clogging cast iron vortex design passes 3/4″ (19 mm) spherical solids
  • 25′ (8 m), UL listed, 3-wire neoprene cord and plug. Longer cords available in lengths of 35′ – 50′ (11 m – 15 m)
  • No screens to clog
  • Stainless Steel screws, bolts and handle
  • 1-1/2″ NPT discharge with 2″ or 3″ flange available
  • Corrosion-resistant, powder coated epoxy finish
  • Moisture sensors available for early warning of seal failure (optional)
  • 100% computerized tested
Voltage Ability 115 / 200 / 230 / 460
Phase 1 & 3
Hz 60
Discharge Size 1.5″ Standard, 2″ & 3″ Optional
Solids Handling 3/4″
HP 1/2 & 1
RPM 3450
Seals Upper – Carbon Ceramic
Lower – Silicon Carbide/Carbon
O Rings Viton
Impeller  Cast Iron Vortex

SELECTION GUIDE

  1. Single or double piggyback variable level float switch pump control using the 15 amp plug and receptacle. Refer to ZM1536.
  2. Single piggyback variable level float switch, hard wiring the pump lead wires to the float switch leads.
  3. Refer to ZM3376 and select the correct simplex control panel listed for the pump. Refer to ZM1536 and select the desired variable level control switch, 3 required.
  4. Refer to ZM3376 and select the correct duplex control panel listed for the pump. Refer to ZM1536 and select the desired variable level control switch, 3 or 4 required.

Pump Performance Curves

Design Tools