6180 Series
6180 Series
Commercial effluent pumps
Features and Benefits
- Durable, epoxy coated cast iron construction
- Motor : 1 Ph or 3 Ph, oil-filled, hermetically-sealed, automatic reset, thermal overload protected (1 Ph)
- Bearings - Upper and lower ball bearings
- Stainless steel motor shaft
- Dual mechanical shaft seals - upper carbon/ceramic, lower silicon carbide/carbon. Optional seal materials available
- Viton O-ring seals and cover gasket
- Impeller - non-clogging, bronze vortex design passes 3/4" (19 mm) spherical solids
- 25' (8 m), UL listed, 3-wire neoprene cord and plug. Longer cords available in lengths of 35' - 50' (11 m - 15 m)
- No screens to clog
- Stainless steel screws, bolts and handle
- 1-1/2" NPT discharge with 2" or 3" flange available
- Corrosion-resistant, powder coated epoxy finish
- Moisture sensors available for early warning of seal failure (optional)
- 100% computerized tested
Product Specifications
Voltage Ability | 200 / 230 / 460 / 575 |
Phase | 1 & 3 |
Hz | 60 |
Discharge Size | 1.5" Standard, 2" & 3" Optional |
Solids Handling | 3/4" |
HP | 1/2 & 1 |
RPM | 3450 |
Seals | Upper - Carbon Ceramic Lower - Silicon Carbide/Carbon |
O Rings | Viton |
Impeller | Bronze Vortex |
Technical Data
CAUTION
All installation of controls, protection devices and wiring should be done by a qualified licensed electrician. All electrical and safety codes should be followed including the most recent National Electrical Code (NEC) and the Occupational Safety and Health Act (OSHA).
SELECTION GUIDE
- Single or double piggyback variable level float switch pump control using the 15 amp plug and receptacle. Refer to ZM1536.
- Single piggyback variable level float switch, hard wiring the pump lead wires to the float switch leads.
- Refer to ZM1342 and select the correct simplex control panel listed for the pump. Refer to ZM1536 and select the desired variable level control switch, 3 required.
- Refer to ZM1342 and select the correct duplex control panel listed for the pump. Refer to ZM1536 and select the desired variable level control switch, 3 or 4 required.